Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › MASS AIR FLOW METER › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449859 MASS AIR FLOW METER A

G16E-GTS ENGINE CONTROL  MASS AIR FLOW METER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the mass air flow meter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of mass air flow meter sub-assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 22204 1.REMOVE MASS AIR FLOW METER

a.
A480394

Disconnect the mass air flow meter connector.


b.

Remove the 2 screws and mass air flow meter from the air cleaner cap sub-assembly.

NOTICE:

If the mass air flow meter has been struck or dropped, replace it.