Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449860 CAMSHAFT POSITION SENSOR A

G16E-GTS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.SEPARATE ENGINE WIRE

a.
A481031

Remove the bolt and engine wire.


Hide 19500 2.REMOVE IGNITION COIL ASSEMBLY

a.
A481030

Disconnect the ignition coil assembly connector.


b.

Remove the bolt and ignition coil assembly.


Hide 11102A 3.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A480395

Disconnect the camshaft position sensor connector.


b.

Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



c.
A480471

Remove the O-ring from the camshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.

·

If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.




Hide 11102A 4.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A480396

Disconnect the camshaft position sensor connector.


b.

Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



c.
A480473

Remove the O-ring from the camshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.

·

If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.