Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449860 CAMSHAFT POSITION SENSOR A

G16E-GTS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A480471

Clean the O-ring groove of the camshaft position sensor.

NOTICE:

Make sure the O-ring groove is free of foreign matter.



b.

Install a new O-ring to the camshaft position sensor.

NOTICE:

Set the O-ring on the tip of the camshaft position sensor and roll it into the O-ring groove with bare hands to install it.



c.

Check if the O-ring is twisted.


d.
A480395

Install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




e.

Connect the camshaft position sensor connector.


Hide 11102A 2.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A480473

Clean the O-ring groove of the camshaft position sensor.

NOTICE:

Make sure the O-ring groove is free of foreign matter.



b.

Install a new O-ring to the camshaft position sensor.

NOTICE:

Set the O-ring on the tip of the camshaft position sensor and roll it into the O-ring groove with bare hands to install it.



c.

Check if the O-ring is twisted.


d.
A481164C01
1.688,2.958 2,3.156 0.313,0.198 10 false *a 2.76,2.969 3.073,3.167 0.313,0.198 10 false *b
*a Torque Wrench Fulcrum Length
*b Union Nut Wrench Fulcrum Length


Using a 10 mm union nut wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

Torque:
Specified Tightening Torque : 10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 8.8 N*m (90 kgf*cm, 78 in.*lbf)




e.

Connect the camshaft position sensor connector.


Hide 19500 3.INSTALL IGNITION COIL ASSEMBLY

a.

Install the bolt and ignition coil assembly.

Torque:
10 N・m (102 kgf・cm, )


b.

Connect the ignition coil assembly connector.


Hide 4.INSTALL ENGINE WIRE

a.

Install the bolt and engine wire.

Torque:
10 N・m (102 kgf・cm, )


Hide 5.INSPECT FOR ENGINE OIL LEAK