Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449862 IGNITION COIL AND SPARK PLUG A

G16E-GTS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 19500 1.REMOVE IGNITION COIL ASSEMBLY

a.
A480398

Disconnect the 3 ignition coil assembly connectors.


b.

Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.



Hide 19100P 2.REMOVE SPARK PLUG