Home › Engine / Hybrid System › G16E-GTS (COOLING) › RADIATOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095909 G16E-GTS COOLING _0449892 RADIATOR G

G16E-GTS COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16475A 1.INSPECT RESERVE TANK CAP

CAUTION:

Do not remove the reserve tank cap and air release valve while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.
A287226C04
2.063,1.458 2.458,1.458 false 0.813,1.698 1.219,1.698 false 0.646,1.615 0.958,1.771 0.313,0.156 10 *a 2.5,1.375 2.813,1.531 0.313,0.156 10 *b
*a O-ring
*b Rubber Packing


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.


ii.

Check that the O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.


iv.

Install the radiator cap tester to the reserve tank cap.


v.
A249860C06
2.104,0.156 1.938,0.156 1.938,0.156 1.625,0.469 false 0.979,0.26 0.813,0.26 0.813,0.26 0.5,0.573 false 0.635,1.073 0.854,1.313 0.219,0.24 10 *b 2.167,0.073 2.438,0.354 0.271,0.281 10 *a 1.042,0.177 1.281,0.417 0.24,0.24 10 *1
*1 Reserve Tank Cap
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it upwards 30° or more.


vi.

Pump the radiator cap tester several times, and check the maximum pressure.

Pump Speed:

1 pump per second


Result:
Item Specified Condition
Standard pressure
(for brand-new reserve tank cap)
93 to 123 kPa (0.9 to 1.3 kgf/cm2, 13.5 to 18.0 psi)
Minimum pressure
(for used reserve tank cap)
79 kPa (0.8 kgf/cm2, 11.5 psi)


HINT:

Even if the reserve tank cap cannot maintain the maximum pressure, it is not a defect.


If the maximum pressure is less than the minimum pressure, replace the reserve tank cap.


vii.

Remove the radiator cap tester from the reserve tank cap.