Home › Engine / Hybrid System › STOP AND START › VACUUM SENSOR ASSEMBLY › 2020.09–2021.11
RM36W0E _51 Engine / Hybrid System _090986 STOP AND START _0431196 VACUUM SENSOR ASSEMBLY A

STOP AND START  VACUUM SENSOR ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 47201 1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for Gasoline Model TMMF Made LHD)

Hide 47201 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for Gasoline Model TMMF Made RHD)

Hide 47201 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for Gasoline Model TMC Made LHD)

Hide 47201 4.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for Gasoline Model TMC Made RHD)

Hide 89420H 5.REMOVE VACUUM SENSOR ASSEMBLY

a.
A468073C01
0.073,0.406 0.313,0.635 0.24,0.229 12 true *A 0.063,2.698 0.354,2.906 0.292,0.208 12 true *B
*A for LHD
*B for RHD


for TMMF Made:

i.

Disconnect the vacuum sensor assembly connector from the vacuum sensor assembly.


ii.

Remove the vacuum sensor assembly from the brake booster assembly.



b.
A476529C01
0.031,0.042 0.271,0.26 0.24,0.219 12 true *A 0.042,2.521 0.302,2.729 0.26,0.208 12 true *B
*A for LHD
*B for RHD


for TMC Made:

i.

Disconnect the vacuum sensor assembly connector from the vacuum sensor assembly.


ii.

Remove the vacuum sensor assembly from the brake booster assembly.



Hide 6.REMOVE VACUUM SENSOR GROMMET

a.

Remove the vacuum sensor grommet from the brake booster assembly.