The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEAT BACK COVER
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
72494A
5.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)
72552B
6.REMOVE RECLINING HINGE COVER
72526
7.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849
8.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)
71812D
9.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)
71862
10.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
71811D
11.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)
71861
12.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
13.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71072S
15.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510L
16.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY
for Standard Seat Type:
Remove the 19 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.
for Sports Seat Type:
Remove the 19 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.