Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
Use the same procedure for sports seat type and soprty seat type.
The procedure listed below is for sports seat type.
72498
1.INSTALL VERTICAL ADJUSTER BRACKET COVER (for Driver Side)
Engage the claws to install the vertical adjuster bracket cover.
72125A
2.INSTALL REAR UPPER SEAT TRACK COVER
Use the same procedure for both sides.
|
Install in this Direction |
Engage the claws to install the rear upper seat track cover as shown in the illustration.
72265D
3.INSTALL SEAT TRACK UPPER RAIL COVER
Use the same procedure for both sides.
|
Install in this Direction |
Engage the claws to install the seat track upper rail cover as shown in the illustration.
72211
4.INSTALL SEAT TRACK ADJUSTING HANDLE
Engage the claws to install the seat track adjusting handle to the front seat adjuster assembly.
71052A
5.INSTALL FRONT SEAT CUSHION SPRING SUB-ASSEMBLY
Engage the hooks to install the front seat cushion spring sub-assembly to the front seat adjuster assembly.
72210
6.INSTALL SEAT TRACK CONTROL CABLE ASSEMBLY (for Front Passenger Side)
Engage the casing caps and clamps to install the seat track control cable assembly.
Connect the 2 cable ends.
82824
7.INSTALL WIRING HARNESS CONNECTOR (w/o Seat Heater System)
Engage the claw to remove the wiring harness connector.
7181B
8.INSTALL FRONT SEAT CUSHION WIRE HARNESS HOLDER
Engage the claw to install the front seat cushion wire harness holder.
Install the 2 screws.
71874A
9.INSTALL FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)
| *a | Hook |
| *b | Guide |
Engage the guide and claw.
Engage the hook to install the front seat lower cushion shield LH.
71873U
10.INSTALL FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)
| *a | Hook |
| *b | Guide |
Engage the guide and claw.
Engage the hook to install the front seat lower cushion shield RH.
71876A
11.INSTALL RECLINING ADJUSTER INSIDE COVER LH
Engage the claws to install the reclining adjuster inside cover LH.
71875B
12.INSTALL RECLINING ADJUSTER INSIDE COVER RH
Engage the claws to install the reclining adjuster inside cover RH.
87510L
13.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
71072S
14.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
When installing a separate type front seat cushion cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for 5 Door)>PRECAUTION
for Sports Seat Type:
Engage the claws to install the separate type front seat cushion cover to the separate type front seat cushion pad.
Be careful not to damage the separate type front seat cushion cover.
for Sporty Seat Type:
Engage the claws to install the separate type front seat cushion cover to the separate type front seat cushion pad.
Be careful not to damage the separate type front seat cushion cover.
82667D
15.INSTALL CONNECTOR HOLDER (for Front Passenger Side)
|
Install in this Direction |
Engage the claw to remove the connector holder as shown in the illustration.
16.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Engage the hooks to install the separate type front seat cushion cover with pad.
w/ Seat Heater System:
Engage the claws and clamps to install the front seat cushion heater assembly wire harness.
for Front Passenger Side:
|
Install in this Direction |
Engage the claw to install the occupant detection sensor connector.
71759B
17.INSTALL FRONT SEATBACK HOOK
Engage the claws to install the 2 front seatback hooks to the front seatback frame sub-assembly.
71587B
18.INSTALL FRONT SEATBACK EDGE PROTECTOR
Install the 2 front seatback edge protectors to the front seatback spring sub-assembly.
71054S
19.INSTALL FRONT SEATBACK SPRING SUB-ASSEMBLY
Engage the guides to install the front seatback spring sub-assembly to the front seatback frame sub-assembly.
Engage the claws to install the 2 front seatback edge protectors to the front seatback frame sub-assembly.
73920A
20.INSTALL FRONT SEAT AIRBAG ASSEMBLY
87510N
21.INSTALL FRONT SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
71074S
22.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
When installing a separate type front seatback cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for 5 Door)>PRECAUTION
for Sports Seat Type:
Engage the claws to install the separate type front seatback cover to the separate type front seatback pad.
Be careful not to damage the separate type front seatback cover.
for Sporty Seat Type:
Engage the claws to install the separate type front seatback cover to the separate type front seatback pad.
Be careful not to damage the separate type front seatback cover.
23.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Install the separate type front seatback cover with pad to the front seatback frame sub-assembly.
71930A
24.INSTALL FRONT SEAT HEADREST SUPPORT ASSEMBLY
|
Install in this Direction |
Engage the claws to install the 2 front seat headrest support assemblies as shown in the illustration.
Close the 2 fasteners as shown in the illustration.
Engage the hooks.
71739A
25.INSTALL FRONT SEATBACK BEZEL (for Sports Seat Type)
|
Install in this Direction |
Engage the claws to install the front seatback bezel as shown in the illustration.
26.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
for Driver Side:
Engage the guides to install the separate type front seatback assembly to the separate type front seat cushion assembly.
Install the 4 bolts.
Engage the hooks.
| *1 | Front Seat Airbag Assembly |
| *2 | Front Seatback Heater Assembly |
w/ Seat Heater System:
Connect the connector and engage the clamp to install the front seatback heater assembly wire harness.
Engage the claw and clamps to install the front seat airbag assembly wire harness.
Connect the rubber of the front seatback cover.
for Front Passenger Side:
Engage the guides to install the separate type front seatback assembly to the separate type front seat cushion assembly.
Install the 4 bolts.
Connect the cable end of the seat track control cable assembly.
Engaget the casing cap of the seat track control cable assembly.
Engage the hooks.
| *1 | Front Seat Airbag Assembly |
| *2 | Front Seatback Heater Assembly |
w/ Seat Heater System:
Connect the connector and engage the clamp to install the front seatback heater assembly wire harness.
Engage the claw and clamps to install the front seat airbag assembly wire harness.
71862
27.INSTALL FRONT SEAT INNER CUSHION SHIELD
|
Install in this Direction |
for Driver Side:
Engage the guide and claws as shown in the illustration.
|
Install in this Direction |
Engage the claws to install the front seat inner cushion shield as shown in the illustration.
|
Install in this Direction |
for Front Passenger Side:
Engage the guides and claws as shown in the illustration.
|
Install in this Direction |
Engage the claws to install the front seat inner cushion shield as shown in the illustration.
71812D
28.INSTALL FRONT SEAT CUSHION SHIELD
|
Install in this Direction |
for Driver Side:
Engage the guide as shown in the illustration.
|
Install in this Direction |
Engage the claws as shown in the illustration.
|
Install in this Direction |
Engage the guides and claw as shown in the illustration.
|
Install in this Direction |
Engage the claws to install the front seat cushion shield as shown in the illustration.
|
Install in this Direction |
for Front Passenger Side:
Engage the guide as shown in the illustration.
|
Install in this Direction |
Engage the claw as shown in the illustration.
|
Install in this Direction |
Engage the guides and claws as shown in the illustration.
|
Install in this Direction |
Engage the claws to install the front seat cushion shield as shown in the illustration.
71849
29.INSTALL SEAT ADJUSTER COVER CAP (for Driver Side)
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guides and claws to install the seat adjuster cover cap as shown in the illustration.
72526
30.INSTALL RECLINING ADJUSTER RELEASE HANDLE
|
Install in this Direction |
Engage the guide to install the reclining adjuster release handle as shown in the illustration.
72551
31.INSTALL NO.1 RECLINING HINGE COVER
|
Install in this Direction |
Engage the guide and claw to install the No. 1 reclining hinge cover as shown in the illustration.
72495
32.INSTALL FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)
|
Install in this Direction |
Engage the claw to install the front seat vertical adjuster handle as shown in the illustration.
73240
33.INSTALL FRONT SEAT INNER BELT ASSEMBLY
for Driver Side:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY (for 3 Door)>INSTALLATION
for Front Passenger Side:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY (for 3 Door)>INSTALLATION