Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › VACUUM SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0452484 VACUUM SENSOR G

G16E-GTS ENGINE CONTROL  VACUUM SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421 1.INSPECT E.F.I. VACUUM SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Warm up the engine.


e.

Turn the A/C switch off.


f.

Enter the following menus: Powertrain / Engine / Data List / Turbocharger/Supercharger Inlet Pressure Bank1

Powertrain > Engine > Data List
Tester Display
Turbocharger/Supercharger Inlet Pressure Bank1
50003 372 791

g.

Read the air pressure value from the Data List.

HINT:
·

Standard atmospheric pressure is approximately 101 kPa (abs) (15 psi (abs)).

·

For every 100 m (328 ft) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.




h.

Using a vacuum pump, set the E.F.I. vacuum sensor assembly.


i.

Using a vacuum pump, read the value when pressure is applied and when pressure is decreased.

OK:

The pressure values when applying pressure or decreasing pressure using the vacuum pump and the Data List values are nearly the same.


NOTICE:
·

Do not apply a pressure of 50 kPa (0.5 kgf/cm2, 7.3 psi) or more to the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor).

·

Do not apply a vacuum of 50 kPa (375 mmHg, 14.8 in.Hg) or more to the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor).



HINT:

The pressure value displayed in the Data List is the pressure value indicated on the vacuum pump with the air pressure value added.

Example:
Vacuum Pump Pressure Value Air Pressure Value Equation Data List Value
When vacuum is applied at 30 kPa (225 mmHg, 8.86 in.Hg) 100 kPa (1.0 kgf/cm2, 15 psi) -30 + 100 = 70 70 kPa (0.7 kgf/cm2, 10.2 psi)
When pressure is applied at 20 kPa (0.2 kgf/cm2, 3 psi) 20 + 100 = 120 120 kPa (1.2 kgf/cm2, 17 psi)