Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2020.09
RM36W0E _58 Vehicle Interior _088020 SUPPLEMENTAL RESTRAINT SYSTEMS _0420309 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B166A62  Right Side Restraints Sensor 5 / Left Side Restraints Sensor 5 Signal Compare Failure  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode
B166A62 Right Side Restraints Sensor 5 / Left Side Restraints Sensor 5 Signal Compare Failure The difference between the pressure detected by the side airbag pressure sensor LH and the side airbag pressure sensor RH exceeds a certain value a certain number of times
·

Side airbag pressure sensor LH

·

Side airbag pressure sensor RH

·

Airbag sensor assembly


Comes on Does not apply to test/check mode

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the cable to the auxiliary battery terminal, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART




PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
for 5 Door A
for 3 Door B



A

2.CHECK DTC

B

7.CHECK DTC
2.CHECK DTC
a.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444

Result:
Result Proceed to
No DTCs in the table below are output A
Any of the DTCs in the table below are output B


Malfunction Content System Relevant DTC
Side collision sensor circuit (bus 1) malfunction Airbag system B009383 Left Side Restraints Sensor 3 Value of Signal Protection Calculation Incorrect
B009384 Left Side Restraints Sensor 3 Signal Below Allowable Range
B009385 Left Side Restraints Sensor 3 Signal Above Allowable Range
B009387 Left Side Restraints Sensor 3 Missing Message
B009396 Left Side Restraints Sensor 3 Component Internal Failure
B009883 Right Side Restraints Sensor 3 Value of Signal Protection Calculation Incorrect
B009884 Right Side Restraints Sensor 3 Signal Below Allowable Range
B009885 Right Side Restraints Sensor 3 Signal Above Allowable Range
B009887 Right Side Restraints Sensor 3 Missing Message
B009896 Right Side Restraints Sensor 3 Component Internal Failure
B009B64 Left Side Restraints Sensor 5 Signal Plausibility Failure
B009B83 Left Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect
B009B84 Left Side Restraints Sensor 5 Signal Below Allowable Range
B009B85 Left Side Restraints Sensor 5 Signal Above Allowable Range
B009B87 Left Side Restraints Sensor 5 Missing Message
B009B96 Left Side Restraints Sensor 5 Component Internal Failure
B009E64 Right Side Restraints Sensor 5 Signal Plausibility Failure
B009E83 Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect
B009E84 Right Side Restraints Sensor 5 Signal Below Allowable Range
B009E85 Right Side Restraints Sensor 5 Signal Above Allowable Range
B009E87 Right Side Restraints Sensor 5 Missing Message
B009E96 Right Side Restraints Sensor 5 Component Internal Failure

HINT:

If DTCs in the table above are output, troubleshoot those DTCs first.



A

3.CHECK SIDE AIRBAG PRESSURE SENSOR LH

B

3.CHECK SIDE AIRBAG PRESSURE SENSOR LH
a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Replace the side airbag pressure sensor LH with a new one or known good one.

HINT:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for 5 Door Front Door)>REMOVAL


HINT:
·

When using a new part, since the side airbag pressure sensor RH and LH have the same part number, prepare either one.

·

Use the prepared side airbag pressure sensor to check the side airbag pressure sensor RH as well.




d.

Connect the cable to the negative (-) auxiliary battery terminal.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

g.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

4.CHECK SIDE AIRBAG PRESSURE SENSOR LH
4.CHECK SIDE AIRBAG PRESSURE SENSOR LH

Pre-procedure1

a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

b.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444
HINT:

Codes other than DTC B166A62 may be output at this time, but they are not related to this check.



Result:
Result Proceed to
B166A62 is not output A
B166A62 is output B


Post-procedure1

c.

Turn the ignition switch off.


d.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



e.

Restore the side airbag pressure sensor LH that was replaced for testing to its original location.



A

B

5.CHECK SIDE AIRBAG PRESSURE SENSOR RH
5.CHECK SIDE AIRBAG PRESSURE SENSOR RH
a.

Replace the side airbag pressure sensor RH with a new one or known good one.

HINT:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for 5 Door Front Door)>REMOVAL


HINT:
·

When using a new part, since the side airbag pressure sensor LH and RH have the same part number, prepare either one.

·

Use the prepared side airbag pressure sensor to check the side airbag pressure sensor LH as well.




b.

Connect the cable to the negative (-) auxiliary battery terminal.


c.

Turn the ignition switch to ON, and wait for at least 60 seconds.


d.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

e.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

6.CHECK SIDE AIRBAG PRESSURE SENSOR RH
6.CHECK SIDE AIRBAG PRESSURE SENSOR RH

Pre-procedure1

a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

b.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444
HINT:

Codes other than DTC B166A62 may be output at this time, but they are not related to this check.



Result:
Result Proceed to
B166A62 is not output A
B166A62 is output B


Post-procedure1

c.

Turn the ignition switch off.


d.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



e.

Restore the side airbag pressure sensor RH that was replaced for testing to its original location.



A

B

7.CHECK DTC
a.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444

Result:
Result Proceed to
No DTCs in the table below are output A
Any of the DTCs in the table below are output B


Malfunction Content System Relevant DTC
Side collision sensor circuit (bus 1) malfunction Airbag system B009B64 Left Side Restraints Sensor 5 Signal Plausibility Failure
B009B83 Left Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect
B009B84 Left Side Restraints Sensor 5 Signal Below Allowable Range
B009B85 Left Side Restraints Sensor 5 Signal Above Allowable Range
B009B87 Left Side Restraints Sensor 5 Missing Message
B009B96 Left Side Restraints Sensor 5 Component Internal Failure
B009E64 Right Side Restraints Sensor 5 Signal Plausibility Failure
B009E83 Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect
B009E84 Right Side Restraints Sensor 5 Signal Below Allowable Range
B009E85 Right Side Restraints Sensor 5 Signal Above Allowable Range
B009E87 Right Side Restraints Sensor 5 Missing Message
B009E96 Right Side Restraints Sensor 5 Component Internal Failure

HINT:

If DTCs in the table above are output, troubleshoot those DTCs first.



A

8.CHECK SIDE AIRBAG PRESSURE SENSOR LH

B

8.CHECK SIDE AIRBAG PRESSURE SENSOR LH
a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Replace the side airbag pressure sensor LH with a new one or known good one.

HINT:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for 3 Door Front Door)>REMOVAL


HINT:
·

When using a new part, since the side airbag pressure sensor RH and LH have the same part number, prepare either one.

·

Use the prepared side airbag pressure sensor to check the side airbag pressure sensor RH as well.




d.

Connect the cable to the negative (-) auxiliary battery terminal.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

g.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

9.CHECK SIDE AIRBAG PRESSURE SENSOR LH
9.CHECK SIDE AIRBAG PRESSURE SENSOR LH

Pre-procedure1

a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

b.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444
HINT:

Codes other than DTC B166A62 may be output at this time, but they are not related to this check.



Result:
Result Proceed to
B166A62 is not output A
B166A62 is output B


Post-procedure1

c.

Turn the ignition switch off.


d.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



e.

Restore the side airbag pressure sensor LH that was replaced for testing to its original location.



A

B

10.CHECK SIDE AIRBAG PRESSURE SENSOR RH
10.CHECK SIDE AIRBAG PRESSURE SENSOR RH
a.

Replace the side airbag pressure sensor RH with a new one or known good one.

HINT:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for 3 Door Front Door)>REMOVAL


HINT:
·

When using a new part, since the side airbag pressure sensor LH and RH have the same part number, prepare either one.

·

Use the prepared side airbag pressure sensor to check the side airbag pressure sensor LH as well.




b.

Connect the cable to the negative (-) auxiliary battery terminal.


c.

Turn the ignition switch to ON, and wait for at least 60 seconds.


d.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 444

e.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

11.CHECK SIDE AIRBAG PRESSURE SENSOR RH
11.CHECK SIDE AIRBAG PRESSURE SENSOR RH

Pre-procedure1

a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

b.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444
HINT:

Codes other than DTC B166A62 may be output at this time, but they are not related to this check.



Result:
Result Proceed to
B166A62 is not output A
B166A62 is output B


Post-procedure1

c.

Turn the ignition switch off.


d.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



e.

Restore the side airbag pressure sensor RH that was replaced for testing to its original location.



A

B