The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the H124 radio and display receiver assembly connector.
Disconnect the H127 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H124-2 (US1-) - H127-9 (UDO-) | Always | Below 1 Ω |
| H124-3 (US1+) - H127-10 (UDO+) | Always | Below 1 Ω |
| H124-5 (USG1) - H127-[12] (UJSS) | Always | Below 1 Ω |
| H124-2 (US1-) or H127-9 (UDO-) - Body ground | Always | 10 kΩ or higher |
| H124-3 (US1+) or H127-10 (UDO+) - Body ground | Always | 10 kΩ or higher |
| H124-5 (USG1) or H127-[12] (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG