This circuit provides power to operate the clearance warning ECU assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the O60 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O60-31 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| O60-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V *1
10.5 to 16 V *2 |
| O60-1 (IG) - Body ground | Ignition switch off | Below 1 V |
*1: w/o Stop and Start System
*2: w/ Stop and Start System
| Proceed to |
|---|
| OK |
| NG |
OK
NG