Home › Audio / Visual / Telematics › AUDIO / VIDEO › ACTIVE NOISE CONTROL SYSTEM › from 2020.09
RM36W0E _56 Audio / Visual / Telematics _088597 AUDIO / VIDEO _0449775 ACTIVE NOISE CONTROL SYSTEM C

AUDIO / VIDEO  ACTIVE NOISE CONTROL SYSTEM  B1AB071  Rear Door Left Speaker Circuit Actuator Stuck  


DESCRIPTION

This DTC is output when a malfunction occurs in the left side rear speaker system.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1AB071 Rear Door Left Speaker Circuit Actuator Stuck When starting the system from IG OFF → ACC ON, the stereo component equalizer assembly detects a malfunction in the left side rear speaker system*
·

Harness or connector

·

Rear speaker assembly LH

·

Stereo component equalizer assembly



HINT:

*: To prevent false positives, fault monitoring is not performed in the following conditions:

·

Auxiliary battery voltage has decreased to 9.5 V or less.

·

Less than 3 seconds have elapsed after auxiliary battery voltage returned to normal.



WIRING DIAGRAM

E463281E01
0.406,1.271 1.021,1.469 0.615,0.198 10 false O114 0.417,1.417 2.677,1.708 2.26,0.292 10 false Rear Speaker Assembly LH 2.281,1.094 2.438,1.292 0.156,0.198 10 false 2 2.281,1.677 2.438,1.875 0.156,0.198 10 false 1 5.333,0.906 5.646,1.104 0.313,0.198 10 false 11 5.323,1.625 5.635,1.823 0.313,0.198 10 false 26 5.604,1.01 6.063,1.208 0.458,0.198 10 false RL+ 5.615,1.729 6.073,1.927 0.458,0.198 10 false RL- 5.313,2.146 6.229,2.344 0.917,0.198 10 false O131 5.313,2.313 7.104,2.74 1.792,0.427 10 false Stereo Component Equalizer Assembly

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Active Noise Control > Clear DTCs
50002 415

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Active Noise Control > Trouble Codes
50001 415

Result:
Result Proceed to
DTC B1AB071 is not output A
DTC B1AB071 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (REAR SPEAKER ASSEMBLY LH - STEREO COMPONENT EQUALIZER ASSEMBLY)
3.CHECK HARNESS AND CONNECTOR (REAR SPEAKER ASSEMBLY LH - STEREO COMPONENT EQUALIZER ASSEMBLY)
a.

Disconnect the O114 rear speaker assembly LH connector.


b.

Disconnect the O131 stereo component equalizer assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O114-2 - O131-11 (RL+) Always Below 1 Ω
O114-1 - O131-26 (RL-) Always Below 1 Ω
O114-2 - Body ground Always 10 kΩ or higher
O114-1 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT REAR SPEAKER ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT REAR SPEAKER ASSEMBLY LH

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>QUARTER TRIM SPEAKER>INSPECTION

OK:

Malfunction disappears.


Result:
Proceed to
OK
NG



OK

REPLACE STEREO COMPONENT EQUALIZER ASSEMBLY

NG