Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43211
1.INSTALL STEERING KNUCKLE (for TMC Made G16E-GTS)
Secure the steering knuckle between aluminum plates in a vise.
Do not overtighten the vise.
Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 3 bolts.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.
43211
2.INSTALL STEERING KNUCKLE (for TMC Made except G16E-GTS)
Secure the steering knuckle between aluminum plates in a vise.
Do not overtighten the vise.
Using a 12 mm hexagon socket wrench, install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 3 bolts.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.
43211
3.INSTALL STEERING KNUCKLE (for TMMF, TMMCZ Made)
Secure the steering knuckle between aluminum plates in a vise.
Do not overtighten the vise.
Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 3 bolts.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.
43340A
4.INSTALL FRONT LOWER BALL JOINT ASSEMBLY (for TMC Made G16E-GTS)
43340A
5.INSTALL FRONT LOWER BALL JOINT ASSEMBLY (for TMMF, TMMCZ Made)
6.INSTALL FRONT AXLE ASSEMBLY (for TMC Made G16E-GTS)
7.INSTALL FRONT AXLE ASSEMBLY (for TMC Made except G16E-GTS)
8.INSTALL FRONT AXLE ASSEMBLY (for TMMF, TMMCZ Made)