Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMMF, TMMCZ Made) › from 2021.11
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0491617 REAR AXLE HUB(for TMMF, TMMCZ Made) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMMF, TMMCZ Made)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for Rear Drum Brake)

a.

Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for Rear Disc Brake)

a.

Install the rear axle hub and bearing assembly, rear disc brake dust cover sub-assembly and rear caliper support bracket to the rear axle beam assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 3.INSPECT REAR AXLE HUB BEARING LOOSENESS (for Rear Drum Brake)

Hide 4.INSPECT REAR AXLE HUB BEARING LOOSENESS (for Rear Disc Brake)

Hide 5.INSPECT REAR AXLE HUB RUNOUT (for Rear Drum Brake)

Hide 6.INSPECT REAR AXLE HUB RUNOUT (for Rear Disc Brake)

Hide 89516D 7.CONNECT SKID CONTROL SENSOR WIRE (for Rear Drum Brake)

a.

Connect the skid control sensor wire assembly connector to the rear axle hub and bearing assembly.


Hide 42431D 8.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)

Hide 9.INSTALL REAR DISC (for Rear Disc Brake)

Hide 10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for Rear Disc Brake)

Hide 11.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY (for Rear Disc Brake)

a.

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.


b.

Connect the No. 2 parking brake wire assembly connector to the rear axle hub and bearing assembly.


Hide 12.INSTALL REAR WHEEL