Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43512
1.INSTALL FRONT DISC
| *a | Matchmark |
Align the matchmarks of the front disc and front axle hub sub-assembly, and install the front disc.
When replacing the front disc with a new one, select the installation position where the front disc has minimal runout.
2.INSTALL FRONT DISC BRAKE BUSH DUST BOOT
Install the 2 front disc brake bush dust boots to the front disc brake cylinder assembly.
47750
3.TEMPORARILY INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY
Using a socket hexagon 7 mm, temporarily install the disc brake cylinder with the 2 front disc brake cylinder slide pins.
4.INSTALL FRONT DISC BRAKE PAD
Install the brake pad to the front disc brake cylinder mounting.
There should be no oil or grease on the friction surfaces of the disc brake pads.
47748
5.INSTALL FRONT DISC BRAKE ANTI-RATTLE SPRING
| *a | Sliding Arm A' |
| *b | End A |
Push end A of the front disc brake anti-rattle spring into the groove of the front disc brake cylinder assembly and install spring sliding arm A' onto the front disc brake cylinder mounting anchor.
| *a | End B |
Push the front disc brake anti-rattle spring in the direction of the arrow to flex it until end B can be inserted into the groove of the front disc brake cylinder assembly.
| *a | Sliding Arm B' |
| *b | End B |
While pushing end B of the front disc brake anti-rattle spring into the groove of the disc brake cylinder, flex spring sliding arm B' and install arm B' onto the front disc brake cylinder mounting anchor.
Make sure that the front disc brake anti-rattle spring is securely installed.
47730
6.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY
Install the front disc brake cylinder assembly with front disc brake cylinder mounting to the steering knuckle with the 2 bolts.
47715A
7.INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN
Using a socket hexagon 7 mm, fully tighten the 2 front disc brake cylinder slide pins.
Install the 2 slide pin caps.
8.INSTALL FRONT FLEXIBLE HOSE
Connect the flexible hose with a new union bolt and a new gasket.
Install the flexible hose lock securely into the lock hole in the disc brake cylinder.
9.BLEED BRAKE LINE
10.BLEED CLUTCH LINE (for Manual Transaxle)
for 1KR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM (for C551)>BLEEDING
for 1NR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM (for EC6E)>BLEEDING
11.INSTALL FRONT WHEEL