Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75852
1.INSTALL ROCKER PANEL MOULDING (for TMC Made)
Engage the clips to install the rocker panel moulding as shown in the illustration.
|
Protective Tape |
|
Install in this Direction |
Install the 4 grommets.
Install the 6 screws
Install the 6 clips.
Remove the protective tape.
75852
2.INSTALL ROCKER PANEL MOULDING LH (for TMMF, TMMCZ Made)
Engage the clips to install the rocker panel moulding as shown in the illustration.
|
Protective Tape |
|
Install in this Direction |
Install the 3 grommets.
Install the 5 screws.
w/ o Engine Under Cover Assembly:
Install the 2 screws and clip.
Install the 6 clips.
Remove the protective tape.
65632D
3.INSTALL REAR WHEEL HOUSE FRONT PLATE (w/ Engine Under Cover Assembly)