Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF, TMMCZ Made) › from 2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0494153 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF, TMMCZ Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF, TMMCZ Made)  C148A1C  Electronic Brake Booster Motor "A" Temperature Sensor "A" Circuit Voltage Out of Range  C148F62  Electronic Brake Booster Motor Temperature "A" / "B" Signal Compare Failure  C149A1C  Electronic Brake Booster Motor "A" Temperature Sensor "B" Circuit Voltage Out of Range  


DESCRIPTION

When the temperature sensor inside the electric brake booster (brake booster with master cylinder assembly) meets the detection conditions, this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C148A1C Electronic Brake Booster Motor "A" Temperature Sensor "A" Circuit Voltage Out of Range Temp sensor 1 output voltage is 3.27 V or more, or 0.2 V or less, for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster
C148F62 Electronic Brake Booster Motor Temperature "A" / "B" Signal Compare Failure The sum of temp sensor 1 and temp sensor 2 output voltages is within the range of 3.17 V to 3.43 V for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster
C149A1C Electronic Brake Booster Motor "A" Temperature Sensor "B" Circuit Voltage Out of Range Temp sensor 2 output voltage is 3.27 V or more, or 0.2 V or less, for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster

CAUTION / NOTICE / HINT

NOTICE:

After replacing the electric brake booster (brake booster with master cylinder assembly), perform "Calibration" after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF, TMMCZ Made)>UTILITY


PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected


Result:
Result Proceed to
for LHD A
for RHD B



A

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

B

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END