Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF, TMMCZ Made) › from 2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0494153 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF, TMMCZ Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF, TMMCZ Made)  U011087  Lost Communication with Drive Motor Control Module "A" Missing Message  U025E87  Lost Communication with Electronic Brake Booster Control Module "A" Missing Message  U110787  Lost Communication with Power Management Module Missing Message  U115887  Lost Communication with Electronic Brake Booster Control Module "A" (ch2) Missing Message  


DESCRIPTION

The electric brake booster (brake booster with master cylinder assembly) receives signals from the hybrid vehicle control ECU, inverter with converter assembly, certification ECU (smart key ECU assembly) and skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U011087 Lost Communication with Drive Motor Control Module "A" Missing Message When the IG terminal voltage is 10 V or more, data from the inverter with converter assembly cannot be received for 2 seconds or more.
·

CAN communication system

·

Inverter with converter assembly

·

Skid control ECU (brake actuator assembly)


Brake Booster
U025E87 Lost Communication with Electronic Brake Booster Control Module "A" Missing Message When the IG terminal voltage is 10 V or more, communication between the electric brake booster (brake booster with master cylinder assembly) and the skid control ECU (brake actuator assembly) is abnormal for 2 seconds or more.
·

CAN communication system

·

Electric brake booster (brake booster with master cylinder assembly)

·

Skid control ECU (brake actuator assembly)


Brake Booster
U110787 Lost Communication with Power Management Module Missing Message When the IG terminal voltage is 10 V or more, data from the certification ECU (smart key ECU assembly) cannot be received for 3 seconds or more.
·

CAN communication system

·

Certification ECU (smart key ECU assembly)

·

Skid control ECU (brake actuator assembly)


Brake Booster
U115887 Lost Communication with Electronic Brake Booster Control Module "A" (ch2) Missing Message When the IG terminal voltage is 10 V or more, electric brake booster (brake booster with master cylinder assembly) and skid control ECU (brake actuator assembly) communication malfunction occurs for 2 seconds or more.
·

CAN communication system

·

Electric brake booster (brake booster with master cylinder assembly)

·

Skid control ECU (brake actuator assembly)


Brake Booster

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Brake Booster > Clear DTCs
50002 466

b.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT (HEALTH CHECK)
2.CHECK DTC OUTPUT (HEALTH CHECK)
a.

Using the GTS to operate the Health Check.


b.

Check for DTCs.


Result:
Result Proceed to
DTCs for related systems are output together with U011087, U025E87, U110787 or U115887. A
DTC U011087, U025E87, U110787 or U115887. is output. B
DTCs are not output. C



A

GO TO DIAGNOSTIC TROUBLE CODE CHART (RELATED SYSTEM)

B

C