*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the problem.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Check and record DTCs and Freeze Frame Data.
Check and record DTCs.
Check and record Freeze Frame Data.
Clear the DTCs and Freeze Frame Data.
Reconfirm the DTCs.
Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data.
When CAN communication system DTCs are output, repair the CAN communication system first.
If DTCs related to momentary interruptions are output, perform troubleshooting for those DTCs first.
If the GTS cannot communicate with the skid control ECU (brake actuator assembly), inspect the CAN communication system.
If there is no response from the skid control ECU (brake actuator assembly), inspect the IGR circuit and +BS circuit of the skid control ECU (brake actuator assembly).
Click here
Check the Vehicle Control History.
| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output (problem symptom occurs) | B |
| DTCs are not output (problem symptom does not occurs) | C |
| DTCs are not output (vehicle control history occurs) | D |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
D
After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.
Confirm the diagnostic trouble code chart and perform troubleshooting.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the problem symptoms are listed in the problem symptoms table.
| Result | Proceed to |
|---|---|
| The problem symptoms are not listed in the problem symptoms table. | A |
| The problem symptoms are listed in the problem symptoms table. | B |
A
B
ON-VEHICLE INSPECTION
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF, TMMCZ Made LHD)>ON-VEHICLE INSPECTION
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF Made RHD)>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the precautions before performing adjustment, repair or replacement.
| Proceed to |
|---|
| NEXT |
NEXT
Operate the GTS to clear the codes.
Press the DTC clear button.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the same DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
Confirm the problem symptoms table and perform troubleshooting.
| Proceed to |
|---|
| NEXT |
NEXT