Refer to DTC C050C18
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C050C1F | Left Rear Wheel Speed Sensor Circuit Intermittent | ·
The speed sensor signal is excessively noisy. ·
The calculated change in wheel speed is more than 980 m/s2 for 5*1 or 20*2 seconds or more. ·
The calculated change in wheel speed fluctuates between more than 500 m/s2 and less than -500 m/s2 for 5*1 or 20*2 seconds or more. ·
When the vehicle speed is low, excessive noise in the speed sensor pulse signal is detected 3 times or more within 0.005 second for 5*1 or 20*2 seconds or more. |
·
Rear speed sensor LH (rear axle hub and bearing assembly LH) ·
Rear speed sensor rotor LH (rear axle hub and bearing assembly LH) |
Brake |
*1: The stop light switch assembly is OFF.
*2: The stop light switch assembly is ON.
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
The rear speed sensor LH and rear speed sensor rotor LH are incorporated into the rear axle hub and bearing assembly LH.
If the rear speed sensor LH and/or rear speed sensor rotor LH need to be replaced, replace the rear axle hub and bearing assembly LH.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB (for TMMF, TMMCZ Made)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT