Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF, TMMCZ Made) › from 2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0494155 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made)  C05511C  Longitudinal Acceleration Sensor Circuit Voltage Out of Range  C05512A  Longitudinal Acceleration Sensor Signal Stuck In Range  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

The skid control ECU (brake actuator assembly) performs sensitivity compensation of the longitudinal acceleration signal based on the steering sensor, wheel speed sensor and yaw rate sensor signals, and stores the following DTCs if a malfunction is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C05511C Longitudinal Acceleration Sensor Circuit Voltage Out of Range
·

While the vehicle is being driven at a constant speed and the slowest wheel speed is 3 km/h (2 mph) or less, the longitudinal acceleration signal output value is outside the range of -0.8 to 0.8 g for more than a certain period of time.

·

When the vehicle is being driven at a constant speed, the longitudinal acceleration signal output value is outside the range of -0.2 to 0.5 g for more than a certain period of time.

·

When the vehicle speed is 70 km/h (43 mph) or more, the longitudinal acceleration signal output value and the control value calculated by the skid control ECU both have absolute values of 0.2 g or more, and they are in the opposite phase.


·

Acceleration sensor (airbag sensor assembly)

·

Acceleration sensor (airbag sensor assembly) installation


Brake
C05512A Longitudinal Acceleration Sensor Signal Stuck In Range Abnormal result when comparing the longitudinal acceleration value calculated by the skid control ECU with the longitudinal acceleration signal output value.
·

Acceleration sensor (airbag sensor assembly)

·

Acceleration sensor (airbag sensor assembly) installation


Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF, TMMCZ Made)>UTILITY


PROCEDURE

1.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
a.

Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

HINT:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION


OK:

The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.

The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

2.REPLACE AIRBAG SENSOR ASSEMBLY

NG

2.REPLACE AIRBAG SENSOR ASSEMBLY

NEXT

END