2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built from Jan 2006


1. INSTALL NO. 1 COOLER THERMISTOR

E107306E01
  1. Install the sensor onto the evaporator as shown in the illustration.

  1. Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).

    NOTICE:
    If reusing the evaporator, do not reinsert the sensor in the same position that it was in before. Insert it within area C, shown in the illustration.


2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

I101205

HINT:
If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.

Compressor oil:
ND-OIL8 or the equivalent. Add 40 cc (1.35 fl. oz.)

  1. Install the cooler evaporator.

  1. I101204
    Engage the 4 claws and install the heater case lower.

  1. Install the 3 screws.

  1. I101199
    Engage the cooler thermistor connector.


3. INSTALL COOLER EXPANSION VALVE

I101203
  1. Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler expansion valve.

    Compressor oil:
    ND-OIL8 or the equivalent

  1. Install the 2 O-rings onto the cooler evaporator.

  1. Using a hexagon wrench 4, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }


4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

I101202
  1. Install the heater radiator unit onto the air conditioner radiator assembly.

  1. I101620
    Engage the 3 clips and install the clamp.


5. INSTALL NO. 2 AIR DUCT

I101196
  1. Engage the 3 claws and install the air duct.


6. INSTALL NO. 1 AIR DUCT

I101195
  1. Engage the 3 claws and install the air duct.


7. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY

I101193
  1. Engage the claw and install the air mix damper control cable.


8. INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY

I101194
  1. Engage the claw and install the defroster damper control cable.

← INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →