2005-2008 Yaris · Service Manual TRANSMISSION

P0787 Shift / Timing Solenoid Low (Shift Solenoid Valve ST)

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

Shift solenoid valve ST is switched OFF-ON-OFF in accordance with signals from the ECM when up-shifting and down-shifting between the 3rd and the 4th gears. This reduces the shock of gear shifting between these positions.
DTC No.
DTC Detection Condition
Trouble Area
P0787
ECM detects short in solenoid valve ST circuit 4 times when solenoid valve ST is operated. (1-trip detection logic)
  1. Short in shift solenoid valve ST circuit
  2. Shift solenoid valve ST
  3. ECM
P0788
ECM detects open in solenoid valve ST circuit 4 times when solenoid valve ST is not operated. (1-trip detection logic)
  1. Open in shift solenoid valve ST circuit
  2. Shift solenoid valve ST
  3. ECM

MONITOR DESCRIPTION

When there is an open or short circuit in the shift solenoid valve circuit, the ECM detects the problem and the MIL comes on.

WIRING DIAGRAM

C117933E01

INSPECTION PROCEDURE


1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE ST)
C117650E02
  1. Disconnect the transmission wire connector from the transaxle.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    2 (ST) - Body ground
    11 Ω to 15 Ω at 20°C (68°F)



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
C130155E02
  1. Connect the transmission connector to the transaxle.

  1. Disconnect the ECM connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    80 (ST) - Body ground
    11 Ω to 15 Ω at 20 °C (68 °F)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM

3. INSPECT SHIFT SOLENOID VALVE ST
D009034E02
  1. Remove shift solenoid valve ST.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    Solenoid Connector (ST) - Solenoid Body (ST)
    11 to 15 Ω at 20 °C (68 °F)

  1. Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.

OK:
The solenoid makes operating sounds.



NG
REPLACE SHIFT SOLENOID VALVE ST
OK

REPAIR OR REPLACE TRANSMISSION WIRE


← P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2) (from Aug 2005)P0973 Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1) (+ P0974) (from Aug 2005) →