INSTALLATION
Removal / installation · Vehicles built from Jan 2006
| 1. INSTALL COMBINATION METER ASSEMBLY |
![]() ![]() |
Install the combination meter assembly with the 2 screws.
- NOTICE:
- Install the combination meter so that the rib of the combination meter is held between the instrument panel and the instrument cluster finish panel.
Connect the 2 connectors.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL |
![]() ![]() |
Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.
Engage the 5 claws and 5 clips and install the instrument cluster finish panel.

| 3. INSTALL INSTRUMENT PANEL FINISH PANEL END RH |
![]() ![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.
| 4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH |
![]() ![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.
| 5. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() ![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }





