DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2005
| DATA LIST |
- HINT:
- By referring to the DATA LIST displayed on the intelligent tester, the value and status of parts such as switches, sensors and actuators can be read without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method of shortening diagnostic time.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the following menu items: Chassis / ABS/VSC/TRC / Data List.
Item (Display)
Measurement Item / Range (Display)
Normal Condition
Diagnostic Notes
ABS Warning Light
ABS warning light / ON or OFF
ON: ABS warning light ON
OFF: ABS warning light OFF
-
Brake Warning Light
BRAKE warning light / ON or OFF
ON: BRAKE warning light ON
OFF: BRAKE warning light OFF
-
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch / ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Deceleration Sensor
Deceleration sensor reading / min.: -25.11 m/s, max.: 24.91 m/s
Approximately 0+-0.13 while stationary
-
Forward and Rearward G
Forward and rearward G
min.: -25.11 m/s2
max.: 24.91 m/s2
-
FR Wheel Speed
Wheel speed sensor (FR) reading : min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Similar to speed indicated on speedometer
FL Wheel Speed
Wheel speed sensor (FL) reading : min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Similar to speed indicated on speedometer
RR Wheel Speed
Wheel speed sensor (RR) reading : min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Similar to speed indicated on speedometer
RL Wheel Speed
Wheel speed sensor (RL) reading : min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Similar to speed indicated on speedometer
Vehicle Speed
Maximum speed sensor reading : min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Similar to speed indicated on speedometer
FR Wheel Acceleration
FR wheel acceleration / min.: -25.11 m/s2, max.: 24.91 m/s2
min.: -200.84 m/s2
max.: 199.27 m/s2
-
FL Wheel Acceleration
FL wheel acceleration / min.: -25.11 m/s2, max.: 24.91 m/s2
min.: -200.84 m/s2
max.: 199.27 m/s2
-
RR Wheel Acceleration
RR wheel acceleration / min.: -25.11 m/s2, max.: 24.91 m/s2
min.: -200.84 m/s2
max.: 199.27 m/s2
-
RL Wheel Acceleration
RL wheel acceleration / min.: -25.11 m/s2, max.: 24.91 m/s2
min.: -200.84 m/s2
max.: 199.27 m/s2
-
FR Wheel ABS Ctrl Status
FR wheel ABS control status / ON or OFF
ON: During control
-
FL Wheel ABS Ctrl Status
FL wheel ABS control status / ON or OFF
ON: During control
-
RR Wheel ABS Ctrl Status
RR wheel ABS control status / ON or OFF
ON: During control
-
RL Wheel ABS Ctrl Status
RL wheel ABS control status / ON or OFF
ON: During control
-
Solenoid Relay
Solenoid relay / ON or OFF
ON: Solenoid relay ON
OFF: Solenoid relay OFF
-
ECB Motor Relay
ABS Motor relay / ON or OFF
ON: Motor relay ON
OFF: Motor relay OFF
-
ABS Solenoid (SFRH) (*1)
ABS solenoid (SFRH) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SFRR) (*2)
ABS solenoid (SFRR) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SFLH) (*3)
ABS solenoid (SFLH) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SFLR) (*4)
ABS solenoid (SFLR) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SRRH) (*5)
ABS solenoid (SRRH) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SRRR) (*6)
ABS solenoid (SRRR) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SRLH) (*7)
ABS solenoid (SRLH) / ON or OFF
ON: Operates
OFF: Does not operate
-
ABS Solenoid (SRLR) (*8)
ABS solenoid (SRLR) / ON or OFF
ON: Operates
OFF: Does not operate
-
FR Speed Open
FR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
FL Speed Open
FL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RR Speed Open
RR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RL Speed Open
RL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Number of DTC
Number of recorded DTCs / min.: 0, max.: 255
min.: 0
max.: 255
-
- HINT:
-
*1: SFRH (S: Solenoid, F: Front, R: Right, H: Holding)
-
*2: SFRR (S: Solenoid, F: Front, R: Right, R: Reduction)
-
*3: SFLH (S: Solenoid, F: Front, L: Left, H: Holding)
-
*4: SFLR (S: Solenoid, F: Front, L: Left, R: Reduction)
-
*5: SRRH (S: Solenoid, R: Rear, R: Right, H: Holding)
-
*6: SRRR (S: Solenoid, R: Rear, R: Right, R: Reduction)
-
*7: SRLH (S: Solenoid, R: Rear, L: Left, H: Holding)
-
*8: SRLR (S: Solenoid, R: Rear, L: Left, R: Reduction)
-
*1: SFRH (S: Solenoid, F: Front, R: Right, H: Holding)
| ACTIVE TEST |
- HINT:
- Performing the ACTIVE TEST using the intelligent tester allows parts such as relays and actuators to be operated without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one method of shortening diagnostic time.
- It is possible to display the DATA LIST during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the intelligent tester on.
By following the prompts on the tester, perform the ACTIVE TEST.
- HINT:
- The ignition switch must be turned on (IG) to proceed to the ACTIVE TEST using the intelligent tester.
- The ACTIVE TESTs of the ABS solenoid, ABS motor relay, ABS warning light and BRAKE warning light are available when the vehicle is stopped.
- The motors stop automatically after 5 seconds of activation to prevent them from being damaged. When the motors are driven repeatedly, certain intervals are required.
- Each solenoid stops automatically after 2 seconds of activation to prevent them from being damaged, and can be operated again after a certain interval.
- Do not depress the brake pedal while only the pressure reduction solenoid valves are on.
- Do not drive 2 or more solenoids simultaneously except to operate the pressure holding solenoid valves and pressure reduction solenoid valves of each wheel.
- The ignition switch must be turned on (IG) to proceed to the ACTIVE TEST using the intelligent tester.
Item (Display)
Test Details
Diagnostic Notes
ABS Warning Lamp
Turns ABS warning light ON or OFF
Observe combination meter
Brake Warning Lamp
Turns BRAKE warning light ON or OFF
Observe combination meter
Solenoid Relay
Turns ABS solenoid relay ON or OFF
-
Motor Relay
Turns ABS motor relay ON or OFF
Operation sound of motor can be heard
ABS Solenoid (SRLR)
Turns ABS solenoid (SRLR) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRLH)
Turns ABS solenoid (SRLH) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRR)
Turns ABS solenoid (SRRR) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRH)
Turns ABS solenoid (SRRH) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLR)
Turns ABS solenoid (SFLR) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLH)
Turns ABS solenoid (SFLH) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRR)
Turns ABS solenoid (SFRR) ON or OFF
Operation sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRH)
Turns ABS solenoid (SFRH) ON or OFF
Operation sound of solenoid (clicking sound) can be heard