2005-2008 Yaris · Service Manual BRAKE

DATA LIST / ACTIVE TEST

System information · Vehicles built from Nov 2005


DATA LIST

HINT:
By referring to the DATA LIST displayed on the intelligent tester, the value and status of parts such as switches, sensors and actuators can be read without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method of shortening diagnostic time.

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Select the following menu items: Chassis / ABS/VSC/TRC / Data List.

    Item (Display)
    Measurement Item:
    Range (Display)
    Normal Condition
    Diagnostic Notes
    ABS Warning Lamp
    ABS warning light: ON or OFF
    ON: ABS warning light ON
    OFF: ABS warning light OFF
    -
    Brake Warning Lamp
    BRAKE warning light: ON or OFF
    ON: BRAKE warning light ON
    OFF: BRAKE warning light OFF
    -
    Stop Lamp SW
    Stop light switch: ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    Gear Position (*1)
    Gear position information: P/N, R, 1st-6th, FAIL, NOT R
    -
    -
    Shift Information
    Shift information: ON or OFF
    ON: During gear change
    -
    Number of IG ON
    Number of ignition switch on operations since entered into inspection mode
    Min.: 0, Max.: 255
    -
    FR Wheel Speed
    Wheel speed sensor (FR) reading:
    min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar to speed indicated on speedometer
    FL Wheel Speed
    Wheel speed sensor (FL) reading:
    min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar to speed indicated on speedometer
    RR Wheel Speed
    Wheel speed sensor (RR) reading:
    min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar to speed indicated on speedometer
    RL Wheel Speed
    Wheel speed sensor (RL) reading:
    min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar to speed indicated on speedometer
    Vehicle Speed
    Maximum speed sensor reading:
    min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
    Actual wheel speed
    Similar to speed indicated on speedometer
    FR Wheel Acceleration
    FR wheel acceleration:
    min.: -25.11 m/s2, max.: 24.91 m/s2
    Min.: -200.84 m/s2
    Max.: 199.27 m/s2
    -
    FL Wheel Acceleration
    FL wheel acceleration:
    min.: -25.11 m/s2, max.: 24.91 m/s2
    Min.: -200.84 m/s2
    Max.: 199.27 m/s2
    -
    RR Wheel Acceleration
    RR wheel acceleration:
    min.: -25.11 m/s2, max.: 24.91 m/s2
    Min.: -200.84 m/s2
    Max.: 199.27 m/s2
    -
    RL Wheel Acceleration
    RL wheel acceleration: min.: -25.11 m/s2, max.: 24.91 m/s2
    Min.: -200.84 m/s2
    Max.: 199.27 m/s2
    -
    FR Wheel ABS Ctrl Status
    FR wheel ABS control status: ON or OFF
    ON: During control
    -
    FL Wheel ABS Ctrl Status
    FL wheel ABS control status: ON or OFF
    ON: During control
    -
    RR Wheel ABS Ctrl Status
    RR wheel ABS control status: ON or OFF
    ON: During control
    -
    RL Wheel ABS Ctrl Status
    RL wheel ABS control status: ON or OFF
    ON: During control
    -
    FR Wheel EBD Ctrl Status
    FR wheel EBD control status: ON or OFF
    ON: During control
    -
    FL Wheel EBD Ctrl Status
    FL wheel EBD control status: ON or OFF
    ON: During control
    -
    RR Wheel EBD Ctrl Status
    RR wheel EBD control status: ON or OFF
    ON: During control
    -
    RL Wheel EBD Ctrl Status
    RL wheel EBD control status: ON or OFF
    ON: During control
    -
    Engine Revolutions
    Engine revolutions:
    min.: 0 r/min, max.: 65535 r/min
    -
    -
    Real Engine Torque
    Real engine torque:
    min.: -1024 Nm, max.: 1016 Nm
    -
    -
    Solenoid Relay
    Solenoid relay: ON or OFF
    ON: Solenoid relay ON
    OFF: Solenoid relay OFF
    -
    ECB Motor Relay
    ABS Motor relay: ON or OFF
    ON: Motor relay ON
    OFF: Motor relay OFF
    -
    ABS Solenoid (SFRH) (*2)
    ABS solenoid (SFRH): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SFRR) (*3)
    ABS solenoid (SFRR): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SFLH) (*4)
    ABS solenoid (SFLH): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SFLR) (*5)
    ABS solenoid (SFLR): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SRRH) (*6)
    ABS solenoid (SRRH): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SRRR) (*7)
    ABS solenoid (SRRR): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SRLH) (*8)
    ABS solenoid (SRLH): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    ABS Solenoid (SRLR) (*9)
    ABS solenoid (SRLR): ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    Number of DTC
    Number of recorded DTCs/ min.: 0, max.: 255
    Min.: 0
    Max.: 255
    -

    HINT:
    1. *1: Only MMT
    2. *2: SFRH (S: Solenoid, F: Front, R: Right, H: Holding)
    3. *3: SFRR (S: Solenoid, F: Front, R: Right, R: Reduction)
    4. *4: SFLH (S: Solenoid, F: Front, L: Left, H: Holding)
    5. *5: SFLR (S: Solenoid, F: Front, L: Left, R: Reduction)
    6. *6: SRRH (S: Solenoid, R: Rear, R: Right, H: Holding)
    7. *7: SRRR (S: Solenoid, R: Rear, R: Right, R: Reduction)
    8. *8: SRLH (S: Solenoid, R: Rear, L: Left, H: Holding)
    9. *9: SRLR (S: Solenoid, R: Rear, L: Left, R: Reduction)


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows parts such as relays and actuator to be operated without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one method of shortening diagnostic time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. By following the prompts on the tester, perform the ACTIVE TEST.

    HINT:
    1. The ignition switch must be turned on (IG) to proceed to the ACTIVE TEST using the intelligent tester.
    2. The ACTIVE TESTs of the ABS solenoid, ABS motor relay, ABS warning light and BRAKE warning light are available when the vehicle is stopped.
    3. The motors stop automatically after 5 seconds of activation to prevent them from being damaged. When the motors are driven repeatedly, certain intervals are required.
    4. Each solenoid stops automatically after 2 seconds of activation to prevent them from being damaged, and can be operated again after a certain interval.
    5. Do not depress the brake pedal while only the pressure reduction solenoid valves are on.
    6. Do not drive 2 or more solenoids simultaneously except to operate the pressure holding solenoid valves and pressure reduction solenoid valves of each wheel.

    Item (Display)
    Test Details
    Diagnostic Notes
    ABS Warning Lamp
    Turns ABS warning light ON or OFF
    Observe combination meter
    Brake Warning Lamp
    Turns BRAKE warning light ON or OFF
    Observe combination meter
    Solenoid Relay
    Turns ABS solenoid relay ON or OFF
    -
    Motor Relay
    Turns ABS motor relay ON or OFF
    Operation sound of motor can be heard
    ABS Solenoid (SRLR)
    Turns ABS solenoid (SRLR) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRLH)
    Turns ABS solenoid (SRLH) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRRR)
    Turns ABS solenoid (SRRR) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SRRH)
    Turns ABS solenoid (SRRH) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFLR)
    Turns ABS solenoid (SFLR) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFLH)
    Turns ABS solenoid (SFLH) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFRR)
    Turns ABS solenoid (SFRR) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard
    ABS Solenoid (SFRH)
    Turns ABS solenoid (SFRH) ON or OFF
    Operation sound of solenoid (clicking sound) can be heard

← FREEZE FRAME DATA (from Nov 2005)DIAGNOSTIC TROUBLE CODE CHART (from Nov 2005) →