2005-2008 Yaris · Service Manual RESTRAINTS

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. With the curtain shield airbag installed on the vehicle, perform a visual check. If there are any defects, such as those mentioned below, replace the front pillar garnish or roof headlining with a new one:
    Any cuts, minute cracks or marked discoloration on the front pillar garnish and roof headlining around the curtain shield airbag.

    C121177


INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

C108105

CAUTION:
For curtain shield airbag removal and installation procedures, see pages Click here and Click here, and carefully follow the correct procedure.

  1. Perform a diagnostic system check (Click here).

  1. With the curtain shield airbag removed from the vehicle, as mentioned below, replace the curtain shield airbag with a new one:

    1. Any cuts, minute cracks or marked discoloration on the curtain shield airbag.
    2. Any cracks or other damage to the connector.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →