2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


3. DISCONNECT FRONT FLEXIBLE HOSE

C107599
  1. Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.


4. REMOVE DISC BRAKE CYLINDER ASSEMBLY

C107600
  1. Fix the slide pin with a spanner, remove the 2 bolts and remove the disc brake cylinder.


5. REMOVE FRONT DISC BRAKE PAD KIT (PAD ONLY)

C107601
  1. Remove the 2 disc brake pads from the disc brake cylinder mounting.


6. REMOVE FRONT ANTI SQUEAL SHIM KIT
  1. Remove the No. 1 anti squeal shim and No. 2 anti squeal shim from each brake pad.


7. REMOVE PAD WEAR INDICATOR NO. 1 PLATE
  1. Remove the indicator plate from each brake pad.


8. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

C121849
  1. Remove the 4 disc brake pad support plates from the disc brake cylinder mounting.


9. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

C116961E01
  1. Remove the slide pin (upper) and slide pin (lower) from the disc brake cylinder mounting.


10. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH

C108929E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the slide bush from the slide pin (lower).


11. REMOVE NO. 1 BUSH DUST BOOT

C108930
  1. Remove the 2 dust boots from the disc brake cylinder mounting.


12. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

C108931
  1. Remove the 2 bolts and remove the disc brake cylinder mounting from the steering knuckle.


13. REMOVE FRONT DISC

C108932E01
  1. Place matchmarks on the disc and axle hub and remove the disc.

← COMPONENTS (from Aug 2005)DISASSEMBLY (from Aug 2005) →