REMOVAL
Removal / installation · Vehicles built from Aug 2005
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- Set the headlight leveling switch to 0 (zero) before conducting the procedure.
- Use the same procedure for both the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler) |
Remove the 5 screws and the front spoiler cover.

| 3. REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler) |
Remove the 4 screws and the front spoiler cover.

| 4. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

w/ Front Spoiler:

Remove the 3 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/o Front Spoiler:

Remove the 8 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/ Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
w/ Front Spoiler:

Remove the 2 clips and the 4 screw grommets.
w/o Front Spoiler:

Remove the 2 clips and the screw grommet.
| 5. REMOVE HEADLIGHT ASSEMBLY |
![]() ![]() |
Remove the 3 screws.
w/ Headlight leveling:
Disconnect the 4 connectors, then remove the headlight.
w/o Headlight leveling:
Disconnect the 3 connectors, then remove the headlight.

