REMOVAL
Removal / installation · Vehicles built from Jan 2006
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- Set the headlight leveling switch to 0 (zero) before conducting the procedure.
- Use the same procedure for both the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT BUMPER COVER |
Apply protective tape, as shown in the illustration.

Remove the 7 screws and 3 bolts.

Remove the 2 screw grommets.
Remove the 6 clips.
w/ Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Remove the 2 clips and the screw grommet.

| 3. REMOVE HEADLIGHT ASSEMBLY |
Remove the 2 screws and the bolt.

w/ Headlight leveling:
Disconnect the 3 connectors, then remove the headlight.
w/o Headlight leveling:
Disconnect the 2 connectors, then remove the headlight.
