2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A128348
    Remove the nut, and disconnect the lead wire from the magnet starter switch.

  1. A128349
    Using a torx socket wrench (T25), remove the 3 screws holding the magnet starter switch onto the starter drive housing.

  1. Remove the magnet starter switch.

  1. Remove the return spring.

  1. A128350E01
    Remove the plunger from the starter pinion drive lever.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A128351
    Remove the 2 bolts and starter yoke from the starter drive housing.

  1. A128352E01
    Remove the plate from the planet carrier.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A104840
    Hold the starter yoke in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

  1. A104841E01
    Remove the slotted washer.

  1. A104843E01
    Remove the washer.

  1. Remove the starter commutator end frame from the starter yoke.

  1. A104844E02
    Remove the starter brush holder from the starter armature.

    NOTICE:
    Do not pull on the rubber.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A105361E01
    Remove the starter armature from the starter yoke.


5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A128353
    Remove the 3 planetary gears from the planet carrier.

  1. A128354E01
    Remove the starter center bearing clutch, starter pinion drive lever and starter drive housing cover from the starter drive housing.

  1. A104904E01
    Using a screwdriver, move the pinion stop collar down to the starter clutch.

  1. A104905E01
    Using a screwdriver, remove the snap ring.

  1. A105365E02
    Remove the starter clutch from the planet carrier shaft.


6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY

  1. A105364
    Using 2 screwdrivers, remove the snap ring from the planet carrier shaft.

  1. Remove the washer from the planet carrier shaft.

  1. A105368E01
    Remove the planet carrier shaft from the planet carrier.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →