2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL PLANET CARRIER SHAFT SUB-ASSEMBLY

  1. A105368E01
    Install the planet carrier shaft into the planet carrier.

  1. Install the washer onto the planet carrier shaft.

  1. A105363
    Using a screwdriver, install the snap ring onto the planet carrier shaft.


2. INSTALL STARTER CLUTCH SUB-ASSEMBLY

  1. A105365E03
    Apply grease to the spline of the starter clutch and the planet carrier shaft.

  1. Install the starter clutch onto the planet carrier shaft.

  1. A104907E02
    Install the pinion stop collar and a new snap ring.

  1. A104906E01
    Using a vise, compress the snap ring.

  1. A033587E01
    Using a plastic hammer, lightly tap the planet carrier shaft so that the pinion stop collar is beyond the snap ring while holding the outside of the starter clutch by hand.

  1. A128354E01
    Install the starter center bearing clutch, starter pinion drive lever and starter drive housing cover onto the starter drive housing.

  1. A128353E01
    Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears onto the planet carrier.


3. INSTALL STARTER ARMATURE ASSEMBLY

  1. A105361E01
    Install the starter armature onto the starter yoke.


4. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. A104844E01
    Hold the starter yoke in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. While compressing the spring, install the starter brush holder onto the starter armature.

    NOTICE:
    Align the cutout of the starter yoke and the rubber and install the starter brush holder.

  1. A104843E01
    Install the starter commutator end frame onto the starter yoke.

  1. Install the washer onto the starter commutator end frame.

  1. A104841E02
    Apply grease to the slotted washer.

  1. Install the slotted washer.

  1. A104840
    Install the starter commutator end frame cover onto the starter commutator end frame with the 2 screws.

    Torque:
    1.4 N*m{ 14 kgf*cm , 12 in.*lbf }


5. INSTALL STARTER YOKE ASSEMBLY

  1. A128352E01
    Install the plate onto the planet carrier.

  1. A128358E01
    Align the groove of the yoke and the starter drive housing cover and install the starter yoke onto the starter drive housing.

  1. A128351
    Install the starter yoke onto the starter drive housing with the 2 bolts.

    Torque:
    4.8 N*m{ 49 kgf*cm , 42 in.*lbf }


6. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A128350E02
    Apply grease to the hook.

  1. Install the plunger onto the starter pinion drive lever.

  1. A128349
    Install the return spring onto the magnet starter switch.

  1. Using a torx socket wrench (T25), install the magnet starter switch with the 3 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. A128348
    Connect the lead wire to the terminal with the nut.

    Torque:
    8.5 N*m{ 86 kgf*cm , 75 in.*lbf }

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →