2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. REMOVE REAR SEAT CUSHION ASSEMBLY

  1. B134922
    Hold the front edge of the rear seat cushion cover pad and lift it up, as shown in the illustration, to disengage the 2 hooks.

    NOTICE:
    Hold the area around the hooks so as to avoid deforming the rear seat cushion frame.

  1. Pass the rear seat inner belt through the slit in the rear seat cushion cover pad, disengage the hook between the rear seat cushion cover pad and the rear seatback, and remove the rear seat cushion cover pad.


2. REMOVE REAR FLOOR SERVICE HOLE COVER

A118713
  1. Remove the clip from the floor carpet.

  1. A118728
    Remove the rear floor service hole cover.

  1. A119173
    Disconnect the fuel pump connector.


3. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

5. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

A119169
  1. Widen the tip of the tube joint clip and pull out the clip.

  1. Pull out the fuel tank main tube to disconnect it.

    NOTICE:
    1. Keep the O-ring free of foreign matter, as it becomes contaminated easily.
    2. Do not use any tools in this procedure.
    3. Do not forcefully bend or twist the tube.
    4. Put the tube in a plastic bag to prevent damage and contamination.
    5. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    6. Do not damage any clips. If a clip is damaged, replace it.


6. DISCONNECT FUEL EMISSION TUBE NO. 2

A115476
  1. Loosen the clamp and disconnect fuel emission tube No. 2.


7. DISCONNECT CANISTER OUTLET HOSE SUB-ASSEMBLY NO. 1

A115477
  1. Disconnect the canister outlet hose.


8. REMOVE FUEL PUMP GAUGE RETAINER

A119171E01
  1. Using SST, remove the fuel pump gauge retainer.

    SST
    09808-14020   (09808-01410, 09808-01420, 09808-01430)

    HINT:
    Align the claws of the fuel pump gauge retainer and the tips of SST.


9. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

A118739
  1. Remove the fuel suction with pump and gauge tube assembly.

    NOTICE:
    Do not bend the arm of the sender gauge.

  1. A118738
    Remove the fuel suction tube gasket from the fuel tank.


10. REMOVE FUEL SENDER GAUGE ASSEMBLY

A105590
  1. Disconnect the fuel sender gauge connector.

  1. E107756E01
    Unlock the fuel sender gauge, and slide and remove it.

← COMPONENTS (from Jan 2006)INSPECTION (from Jan 2006) →