2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. REMOVE FUEL SENDER GAUGE ASSEMBLY

A159406
A105590

NOTICE:
Do not separate the tube indicated in the illustration.

  1. Disconnect the connector from the fuel sender gauge.

  1. A119156
    Release the lock by sliding the fuel sender gauge upward, as shown in the illustration.


2. REMOVE FUEL PUMP

A105592
  1. Disconnect the connector from the fuel pump harness.

  1. A109341
    Disconnect the fuel pump filter hose.

  1. A119168
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the fuel filter and the fuel pump from the fuel sub-tank.

  1. A119157
    Disengage the 2 claws and remove the fuel suction support.

  1. A105596
    Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump filter and fuel pump from the fuel filter.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.

  1. A119164
    Disconnect the fuel pump harness.

  1. A119163
    Remove the O-ring.

← REMOVAL (from Nov 2006)INSPECTION (from Nov 2006) →