2005-2008 Yaris · Service Manual ENGINE

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Nov 2005

HINT:
Intelligent tester only:
Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.

NOTICE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or OFF during check mode.


CHECK MODE PROCEDURE

  1. A107925E01
    Turn the ignition switch off.

  2. Make sure that the vehicle is in the following condition:

    1. Battery voltage is 11 V or more.

    2. Accelerator pedal released.

    3. Parking brake lever released.

    4. Shift lever is in N position.

    5. A/C switch is turned OFF.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch on (IG) and turn the intelligent tester on.

  5. A076900E02
    Select the following menu items: Powertrain / Engine and ECT / Check Mode.

  6. Make sure that the MIL flashes as shown in the illustration.

  7. Start the engine (the MIL should turn OFF).

  8. Simulate the conditions of the malfunction described by the customer.

  9. Check the DTC(s) and freeze frame data using the intelligent tester.

  10. After checking the DTC, inspect the appropriate circuits (Click here).

← DTC CHECK / CLEAR (from Nov 2005)FAIL-SAFE CHART (from Nov 2005) →