2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Aug 2005

HINT:
The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.


1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

  1. E107769E01
    Using an air riveter or hand riveter, install the front No. 1 speaker assembly onto the front door panel with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. H002440
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. H002442
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.

  1. E107770
    Connect the connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

B127219
  1. Connect the front door lock remote control cable and front door inside locking cable.

  1. B116821
    5 Door:
    Engage the 8 clips and install the front door trim board.

  1. B116822
    3 Door:
    Engage the 9 clips and install the front door trim board.

  1. B107840
    Tighten the 4 screws.


3. INSTALL FRONT ARMREST BASE PANEL UPPER

B127219
  1. Connect the front door lock remote control cable and front door inside locking cable.

  1. B116821
    5 Door:
    Engage the 8 clips and install the front door trim board.

  1. B116822
    3 Door:
    Engage the 9 clips and install the front door trim board.

  1. B107840
    Tighten the 4 screws.


4. INSTALL DOOR ARMREST COVER

B116818
  1. for 5 Door:
    Engage the 8 claws and 3 clips and install the door armrest cover.

  1. B116851
    for 3 Door:
    Engage the 12 claws and 4 clips and install the door armrest cover.


5. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B116863
  1. Install the window regulator handle plate.

  1. Open all the windows.

  1. B116947E01
    Install the front door window regulator handle with clip at the angle shown in the illustration.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Aug 2005)COMPONENTS (from Aug 2005) →