INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT SPIRAL CABLE |
![]() ![]() |
Check the spiral cable.
Using an ohmmeter, measure the resistance between the terminals.
- Set the spiral cable in the center, and measure the resistance twice, with the spiral cable turned 2.5 times clockwise and 2.5 times counterclockwise.
- Set the spiral cable in a position where it is turned 2.5 times clockwise from the original position, and measure the resistance while turning it 5 times counterclockwise.
- Standard resistance:
Tester connection
Specified condition
A - 2(D+) - D - 1(D+)
Below 1Ω
A - 1(D-) - D - 2(D-)
Below 1Ω
B - 5(HO) - C - 2(HO)
Below 1Ω
- NOTICE:
- To avoid breakage of the spiral cable, do not turn the spiral cable more than necessary. If the result is not as specified, replace the spiral cable.
- Set the spiral cable in the center, and measure the resistance twice, with the spiral cable turned 2.5 times clockwise and 2.5 times counterclockwise.


