REMOVAL
Removal / installation · Vehicles built from Aug 2005
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING PAD (w/o Steering Pad Switch) |
![]() ![]() |
Using "Torx" socket wrench T30, loosen the 2 bolts completely.
Pull the steering pad toward you.
Using a thin-bladed screwdriver, release the locking button.

Using a thin-bladed screwdriver, detach the airbag connector.
Detach the horn connector.
| 3. REMOVE STEERING PAD (w/ Steering Pad Switch) |
![]() ![]() |
Using "Torx" socket wrench T30, loosen the 2 bolts completely.
Pull the steering pad toward you.
Using a thin-bladed screwdriver, release the locking button.

Using a thin-bladed screwdriver, detach the airbag connector.
Detach the horn connector.
| 4. REMOVE STEERING WHEEL ASSEMBLY |
Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.

Using SST, remove the steering wheel assembly.

- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
- NOTICE:
- Apply a small amount of grease to the threads and tip of the SST center bolt before using.
| 5. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System) |
![]() ![]() |
Disengage the 4 claws and remove the steering column cover support.
| 6. REMOVE STEERING COLUMN COVER |
![]() ![]() |
Remove the 3 screws.
Disengage the 2 claws and remove the steering column cover (lower).
Disengage the 2 claws and remove the steering column cover (upper).
| 7. REMOVE SPIRAL CABLE (w/o Steering Sensor) |
![]() ![]() |
Detach the horn connector.
Slide the slider and detach the airbag connector.
Disengage the 3 claws and remove the spiral cable.

| 8. REMOVE SPIRAL CABLE (w/ Steering Sensor) |
![]() ![]() |
Detach the horn connector.
Slide the slider and detach the airbag connector.
Detach the steering sensor connector.
Disengage the 3 claws and remove the spiral cable.

| 9. REMOVE STEERING SENSOR (w/ Steering Sensor) |
![]() ![]() |
Disengage the 6 claws, and remove the steering sensor from the spiral cable.







