2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Be sure to read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

B106566
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    2. Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.

  1. Remove the 3 bolts and remove the airbag sensor.

    Torque:
    18 N*m{ 180 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. Do not use an airbag sensor that has been dropped.
    2. Do not subject the airbag sensor to any impact or force.
    3. Confirm that the carpet does not interfere with the installation plane.

  1. Confirm that there is no looseness by shaking the front airbag sensor.

  1. B106567E01
    Connect the connector holder to lock the lever.

    NOTICE:
    Confirm that the lever is locked.

  1. B106568
    Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.


2. INSTALL INSTRUMENT PAD LOWER LH

  1. B132339
    Engage the claw and 3 clips and install the instrument pad lower.

  1. Install screw <I>.


3. INSTALL REAR CONSOLE BOX ASSEMBLY

  1. B132349
    Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.


4. INSTALL CONSOLE BOX CARPET

  1. B132346
    Install the console box carpet.


5. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B132348
    Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.


6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B132347
    Engage the 5 clips and the claw and install the upper console panel.


7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

  1. B132388
    Install the shift lever knob.


8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER

B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.


9. INSTALL INSTRUMENT PAD LOWER LH

B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


11. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVAL (from Jan 2006)COMPONENTS (from Aug 2005) →