2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler)

  1. B119950
    Remove the 5 screws and the front spoiler cover.


3. REMOVE FRONT SPOILER COVER (w/ Front Spoiler)

  1. B119934
    Remove the 4 screws and the front spoiler cover.


4. REMOVE FRONT BUMPER COVER (for Hatchback)

  1. B114359E01
    Apply protective tape as shown in the illustration.

  1. B119953
    w/ Front Spoiler:

    1. Remove the 3 screws.

    2. Remove the 2 screw grommets.

    3. Remove the 7 clips.

  1. B114360
    w/o Front Spoiler:

    1. Remove the 8 screws.

    2. Remove the 2 screw grommets.

    3. Remove the 7 clips.

  1. B114361E01
    w/ Fog Light:

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

    2. Disconnect the 2 fog light connectors.

  1. B114365E01
    w/o Fog Light:

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

  1. B119954
    w/ Front Spoiler:

    1. Remove the 2 clips and the 4 screw grommets.

  1. B114366
    w/o Front Spoiler:

    1. Remove the 2 clips and the screw grommet.


5. REMOVE AIRBAG SENSOR FRONT LH

B106581E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Remove the 2 bolts.

  1. Disengage the 2 claws and remove the front airbag sensor.

  1. B106582E01
    Disconnect the airbag connector.

    NOTICE:
    1. Do not disconnect the airbag connector by pulling the wire harness.
    2. Release the lock without holding the upper side of CPA.


    1. While pushing the housing, slide only the CPA backward (from a provisionally locked state).

    2. Detach the connector while pushing the housing in the provisionally locked state.

      NOTICE:
      1. Do not disconnect the airbag connector by pulling the wire harness.
      2. Release the lock without holding the upper side of CPA.

    3. B106583
      After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →