REMOVAL
Removal / installation · Vehicles built from Nov 2006
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

Remove the 5 screws and the 3 bolts.

Remove the 2 screw grommets.
Remove the 7 clips.

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

Disconnect the 2 fog light connectors.
Remove the 2 clips, the 2 spring nuts and the screw grommet.

| 3. REMOVE FRONT AIRBAG SENSOR |
![]() ![]() |
- CAUTION:
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
Remove the 2 bolts.
Disengage the 2 claws and remove the front airbag sensor.
Disconnect the airbag connector.

- NOTICE:
- Do not disconnect the airbag connector by pulling the wire harness.
- Release the lock without holding the upper side of CPA.
- Do not disconnect the airbag connector by pulling the wire harness.
While pushing the housing, slide only the CPA backward (from a provisionally locked state).
Detach the connector while pushing the housing in the provisionally locked state.
- NOTICE:
- Do not disconnect the airbag connector by pulling the wire harness.
- Release the lock without holding the upper side of CPA.
- Do not disconnect the airbag connector by pulling the wire harness.
After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.


