2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT PRESSURE SENSOR

  1. E110988E04
    Check the wire harness.

    1. Disconnect the connector of the pressure sensor.

    2. Using an ohmmeter, measure the resistance of the wire harness side connector.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body ground
      Below 1 Ω

    3. Turn the ignition switch on (IG).

    4. Measure the voltage of the wire harness side connector.

      Standard voltage:
      Tester Connection
      Specified Condition
      1 - 3
      4.7 to 5.3 V

  1. I100855E01
    Check the pressure sensor.

    1. Set the manifold gauge.

    2. Connect the connector to the pressure sensor.

    3. Warm up the engine.

    4. Switch A/C ON.

    5. Using a voltmeter, measure the voltage between connector terminals (PRE) and (SG-2) of the air conditioner amplifier.

      HINT:
      Check from the rear of the connector while it is connected to the air conditioning amplifier.

      Standard voltage:
      Type
      Tester Connection
      Refrigerant Pressure
      Specified Condition
      Manual Air Conditioning
      6 (PRE) - 11 (SG-1)
      0.196 to 3.14 MPa (2.0 to 32 kgf/cm2)
      0.76 to 4.74 V
      Automatic Air Conditioning
      9 (PRE) - 13 (SG-1)
      0.196 to 3.14 MPa (2.0 to 32 kgf/cm2)
      0.76 to 4.74 V

← INSTALLATION (from Aug 2005)COMPONENTS (from Jan 2006) →