HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2005
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
- The intelligent tester can be used in steps 3, 4, 6, and 9.
- The intelligent tester can be used in steps 3, 4, 6, and 9.
| 1.Vehicle Brought to Workshop |
| |||||
| 2.Customer Problem Analysis |
| |||||
| 3.Connect Intelligent Tester to DLC3 |
| |||||
| 4.Check and Clear DTCs and Freeze Frame Data |
- HINT:
- (Click here).
| |||||
| 5.Visual Inspection |
| |||||
| 6.Setting Check Mode Diagnosis |
- HINT:
- (Click here).
| |||||
| 7.Problem Symptom Confirmation |
- HINT:
- (Click here).
|
||||
|
| 8.Symptom Simulation |
- HINT:
- (Click here).
| |||||
| 9.DTC Check |
- HINT:
- (Click here).
|
||||
|
| 10.Basic Inspection |
- HINT:
- (Click here, Click here and Click here).
|
|||||
| |||||
| 11.Mechanical System Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 12.Hydraulic Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 13.Manual Shifting Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 14.Problem Symptoms Table Chapter 1 |
- HINT:
- (Click here).
|
|||||
| |||||
| 15.Problem Symptoms Table Chapter 2 |
- HINT:
- (Click here).
| |||||
| 16.Part Inspection |
|
| 17.DTC Chart |
- HINT:
- (Click here).
| |||||
| 18.Circuit Inspection |
| |||||
| 19.Repair or Replace |
| |||||
| 20.Confirmation Test |
| |||||