B2271 Ignition Hold Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when the IG output circuits inside the main body ECU are open or short.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2271 |
IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is abnormal |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Start the engine.
Allow the engine to idle for 1 minute or more.
Select the following menu items: Body / Body ECU / DTC.
Read DTCs.
- Result:
Display (DTC output)
Proceed To
B2271
A
No DTC output
B
|
|
||||
| A | |
| 2. INSPECT FUSE (AM2) |
Remove the AM2 fuse from the engine room R/B and J/B.

Check the fuse resistance.
- Standard resistance:
- Below 1 Ω
Reinstall the AM2 fuse.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |
Disconnect the D64 and D65 main body ECU connectors.

Measure the voltage and resistance of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
D65-1 (AM1) - Body ground
10 to 14 V
D64-6 (AM2) - Body ground
10 to 14 V
- Standard resistance:
Tester Connection
Specified Condition
D65-4 (GND2) - Body ground
Below 1 Ω
Reconnect the main body ECU connectors.
|
|
||||
| OK | ||
| ||
