2005-2008 Yaris · Service Manual ENGINE

B2271 Ignition Hold Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

This DTC is output when the IG output circuits inside the main body ECU are open or short.
DTC No.
DTC Detection Condition
Trouble Area
B2271
IG1 relay actuation circuit or IG2 relay actuation circuit inside main body ECU is abnormal
  1. Main body ECU
  1. AM2 fuse
  1. Wire harness

WIRING DIAGRAM

A155193E01

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Start the engine.

  1. Allow the engine to idle for 1 minute or more.

  1. Select the following menu items: Body / Body ECU / DTC.

  1. Read DTCs.

    Result:
    Display (DTC output)
    Proceed To
    B2271
    A
    No DTC output
    B



B
SYSTEM IS OK
A


2. INSPECT FUSE (AM2)

  1. B122728E02
    Remove the AM2 fuse from the engine room R/B and J/B.

  1. Check the fuse resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the AM2 fuse.



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)

  1. B127996E01
    Disconnect the D64 and D65 main body ECU connectors.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    D65-1 (AM1) - Body ground
    11 to 14 V
    D64-6 (AM2) - Body ground
    11 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    D65-4 (GND2) - Body ground
    Below 1 Ω

  1. Reconnect the main body ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2006)B2272 Ignition 1 Monitor Malfunction (from Nov 2006) →