B2273 Ignition 2 Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when a malfunction occurs in the IG output circuit, which is between the IG2 relay actuation circuit inside the main body ECU and the IG2 relay.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2273 |
IG2 relay actuation circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE OF INTELLIGENT TESTER (IG2 RELAY MONITOR (INSIDE)) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body/ Main Body ECU/ Data List / IG2 Relay Mon2.
Read the display on the tester.
- Main Body ECU:
Item
Measurement Item / Display (Range)
Normal Condition
IG2 Relay Mon2
IG2 inner relay monitor / ON or OFF
ON: Ignition switch on (IG)
OFF: Ignition switch off
- OK:
- ON appears on the screen.
|
|
||||
| OK | |
| 2. CHECK SWITCH CONDITION (IGNITION SWITCH) |
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the ignition switch is.
- OK:
- off → on (ACC) → on (IG) → off
|
|
||||
| OK | ||
| ||
| 3. INSPECT INTEGRATION RELAY (IG2 RELAY) |
Remove the integration relay from the engine room relay block.

Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
1B-4 - 1C-1
10 kΩ or higher
1B-4 - 1C-1
Below 1 Ω
(when battery voltage is applied to terminals 1B-2 and 1B-3)
Reinstall the integration relay.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - MAIN BODY ECU) |
Remove the integration relay from the engine room relay block.

Disconnect the D65 main body ECU connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
1B-2 (Integration relay) - D65-5 (IG2D)
Below 1 Ω
1B-3 (Integration relay) - Body ground
Below 1 Ω
1B-2 (Integration relay) or D65-5 (IG2D) - Body ground
10 kΩ or higher
Reinstall the integration relay.
Reconnect the main body ECU connector.
|
|
||||
| OK | ||
| ||
