2005-2008 Yaris · Service Manual ENGINE

B2274 ACC Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

This DTC is output when a malfunction occurs in the ACC output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.
DTC No.
DTC Detection Condition
Trouble Area
B2274
ACC relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. ACC relay
  3. Wire harness

WIRING DIAGRAM

A164978E01

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (ACC RELAY MONITOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body/ Main Body ECU/ Data List / ACC Relay Mon.

  1. Read the display on the tester.

    Main Body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    ACC Relay Monitor
    ACC relay monitor / ON or OFF
    ON: Engine switch on (ACC)
    OFF: Engine switch off

    OK:
    ON appears on the screen.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (ENGINE SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the engine switch is.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT RELAY (ACC RELAY)

  1. B016200E02
    Remove the ACC relay.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (When battery voltage applied to terminals 1 and 2)

  1. Reinstall the relay.



NG
REPLACE ACC RELAY
OK


4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ACC RELAY)

  1. A122227E03
    Remove the ACC relay.

  1. Disconnect the D64 main body ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    D73-2 (ACC relay) - D64-4 (ACCD)
    Below 1 Ω

  1. Reinstall the ACC relay.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2273 Ignition 2 Monitor Malfunction (from Nov 2006)B2275 STSW Monitor Malfunction (from Nov 2006) →