2005-2008 Yaris · Service Manual ENGINE

B2275 STSW Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is output when the engine start request signal circuit inside the main body ECU is open or short.
DTC No.
DTC Detection Condition
Trouble Area
B2275
Engine start request signal circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  1. ECD system (1ND-TV)
  1. Wire harness

WIRING DIAGRAM

A122229E01

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Turn the ignition switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.

Result:
Display (DTC output)
Proceed To
B2275
A
No DTC output
B



B
SYSTEM IS OK
A


2. INSPECT MAIN BODY ECU

  1. A122230E01
    Disconnect the D66 main body ECU connector.

  1. Depress the clutch pedal fully.

  1. Measure the voltage between the ECU terminal and the body ground when operating the ignition switch to crank the engine.

    HINT:
    The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.

    Standard voltage:
    Tester Connections
    Specified Conditions
    STSW (D66-4) - Body ground
    10 to 14 V

  1. Reconnect the main body ECU connector.



NG
Go to step 4
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)

  1. A130568E01
    Disconnect the D66 main body ECU connector.

  1. Disconnect the A49 ECM connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    STSW (D66-4) - STSW (A49-26)
    Below 1 Ω
    STSW (D66-4) or STSW (A49-26) - Body ground
    10 kΩ or higher

  1. Reconnect the main body ECU connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO ECD SYSTEM (1ND-TV)
OK

END (MAIN BODY ECU IS FAULTY)


← B2274 ACC Monitor Malfunction (from Nov 2005)B2276 ACCR Signal Circuit Malfunction (from Nov 2005) →