2005-2008 Yaris · Service Manual RESTRAINTS

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Aug 2005


CHECK MODE (SIGNAL CHECK): DTC CHECK

  1. A107926E09
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Select the SIGNAL CHECK, and proceed checking with the intelligent tester.

    NOTICE:
    Select the SIGNAL CHECK from the DTC CHECK screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through the normal diagnosis mode inspection.

← DTC CHECK / CLEAR (from Aug 2005)DATA LIST / ACTIVE TEST (from Aug 2005) →